Setting Into Operation; Carrying Out Measurements; Voltage Measurements - Monacor DMT-1005 Manual De Instrucciones

4 Setting into Operation

GB
1) Set the rotary switch (2) to the desired
measuring range.
2) The display shows an indication. If not, a
9 V battery must be inserted. If the symbol
chapter 6 "Replacement of battery or fuse".
3) After the operation always switch off the
unit with the rotary switch (position "OFF"),
otherwise the battery will be exhausted
unnecessarily.

5 Carrying out Measurements

Always plug the black test lead into the black
jack "COM" (6) and the red test lead into the
central jack "VΩmA" (5) resp. with measure-
ments in the 10 A DC range into the upper
jack "10A DC" (4).
For a high accuracy always choose the
lowest possible measuring range (e. g. 15 V
in the 20 V range and not in the 200 V range).
If a measuring range has been exceeded, the
unit signalizes "1" or "-1". In this case choose
the next higher range.

5.1 Voltage measurements

For measurements from 42 V on be espe-
cially careful. By no means touch the
object to be measured or the test tips.
The voltage to be measured at maximum
must not exceed 1000 V
Otherwise there is danger of life for the
user!
1) The red test lead must be connected to the
jack "VΩmA" (5). By no means use the
14
is displayed, replace the battery — see
or 750 V~.