INNER LAMP:
Technical data: AC115V/60Hz, 10W
Controlled by the door switch: When open the door, light will turn on, otherwise put down.
Defrosting
Water contained in food or getting into air inside the refrigerator by opening doors may form a layer of frost inside. It will
weaken the refrigeration and waste energy. When it's thick lies between 4mm and 6mm, you should defrost in time.
FREEZER CHAMBER DEFROSTING
Defrosting in freezer chamber is operated manually. Before defrosting, take out food or put into the cold
storing temperature temporarily, then set the knob of the temperature regulator to position "0" where the
compressor will stop working and leave the open until ice and frost dissolve thoroughly, wipe off the
water with soft cloth. You may be sure to set the knob to original position after defrosting.
WARNING:
It's also inadvisable to scrape ice and frost with apparatus, such as sharp tool, wooden bars etc, or with
mechnical devices or other manual means, such as hot water, heating container etc, other than those
recommended by the manufacturee,so as not to damage the inner casing or the surface of the
evaporator.
COLD-STORING CHAMBER DEFROSTING
It is automatic that cold-storing chamber does not need the defrosting operation. Water from defrosting
will be drained into container located in the top of compressor through a drain pipes of the refrigerator
back and evaporate automatically. (As chart)
NOTICE:
Be sure to keep the drain hole unblocked. If blocked, you may canal the eyelet with sharp wooden bars.
P-6