Basic Settings And Additional Functions - IMG STAGELINE TWIST-1LED Manual De Instrucciones

3.3 Basic settings and
additional functions
The menu SET allows to make basic settings
and provides additional functions.
1) Use the button MENU to call up and exit
the menu SET (also see page 2, fig. 4).
2) After calling up the menu, press the button
ENTER. The following menu items can
then be selected with the buttons UP and
DOWN:
Menu
Setting Function
item
... microphone sensitivity
...
⑬
Basic settings and additional functions (I)
1 Factory settings for the manual mode
Light beam with max. brightness and pointing
upwards (downwards), colour white, no gobo
For the factory settings for the DMX mode, see
table fig. 11.
18
no reset
press the button ENTER:
moving head will go to its star-
ting position and will be reset to
its factory settings 1
no function
press the button ENTER:
moving head will go to its star-
ting position (useful when the
head has been turned out of
position by force)
for master / slave mode
no control signals will be sent to
jack DMX OUT
output of control signals
for the show programs
automatic run*
music-controlled run*
* like the buttons SOUND ON /
OFF on the remote control
for the
music-controlled run
= factory setting
Menu
Setting Function
item
press
ENTER
⑭
Basic settings and additional functions (II)
: 2 All settings for the manual mode
made in the DMX mode with the DMX controller
(beam direction, colour, gobo, brightness set-
ting, and setting DMX channel 10 to < 50).
display will constantly
be illuminated
display will extinguish
after 30 sec.;
when MENU, UP, DOWN or
ENTER is pressed, it will be illu-
minated for 30 sec. again
no key lock
The control buttons will be
locked 30 sec. after this setting
was selected. To briefly unlock
the buttons, press MENU,
DOWN, UP, ENTER.
information about the unit
light source (FIX)
date of manufacture
time of manufacture
operating hours counter
current operating time (min.)
total operating time (hours)
for service only
standard indications on display
indications on display rotated
by 180°
(for upside-down installation)
for service only
for service only
no function
to save the current settings for
the manual mode in the
DMX mode 2
for service only
= factory setting
can also be