Eu Declaration Of Conformity - Festool CMS-MOD-BS 120 Manual De Instrucciones

that the internal contour of the insert is 2-3 mm
from the sanding belt. Finally replace the up- per
sanding roller guard and fasten the rear belt cover
at a distance of 3-4 mm from the sanding belt.
9.2 Replacing the sanding base
During sanding the rear of the sanding belt is
pressed against the sanding base in the working
area (6.1). This leads to a certain wear on the sand-
ing base. The sanding base protects the base plate
against wear. A heavily worn sanding base damages
the sanding belt and can no longer protect the base
plate. The sanding base thus has to be periodically
replaced. Remove the old sanding base from its
mounting and affix the new one in its place.
9.3 Replacing the belt guides
Despite attempts at a careful adjustment of the belt
running a certain shift of the sanding belt up or
down is unavoidable after a time. A small ceramic
plate is attached (6.2) to the clamping plate as a
downward start-up limiter so that the belt does not
damage any components. It has to be replaced with
an new plate when worn.
10 Environment
Do not throw the power tool in your household
waste! Dispose of machines, accessories and pack-
aging at an environmentally responsible recycling
centre. Observe the valid national regulations.
EU only: European Directive 2002/96/EC stipulates
that used electric power tools must be collected
separately and disposed of at an environmentally
responsible recycling centre.
Information on REACh:
11

EU Declaration of Conformity

Belt sander module
CMS-BS 120
We declare under sole responsibility that this prod-
uct complies with all the relevant requirements in
the following Directives, standards and normative
documents:
2006/42/EC, 2004/108/EC, 2011/65/EU, EN 60745-
1, EN, EN 55014-1, EN 55014-2, EN 61000-3-2, EN
61000-3-3.
Festool Group GmbH & Co. KG
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
CMS-MOD-BS 120
GB
Serial no
493820
13