Troubleshooting Guide - EINHELL GC-PH 2155 Manual De Instrucciones

9. Troubleshooting guide

Fault
The equipment
does not start
The equipment
starts but does
not develop its full
power
The engine does
not run smoothly
Engine smokes ex-
cessively
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_GC_PH_2155_SPK7.indb 21 Anl_GC_PH_2155_SPK7.indb 21
GB
Possible cause
- Correct starting procedure not follo-
wed
- Sooted or damp spark plug
- Incorrect carburetor setting
- Incorrect choke lever setting
- Soiled air fi lter
- Incorrect carburetor setting
- Incorrect electrode gap on the
spark plug
- Incorrect carburetor setting
- Incorrect fuel mix
- Incorrect carburetor setting
- 21 -
Remedy
- Follow the instructions for starting
- Clean the spark plug or replace it
with a new one
- Contact an authorized customer
service outlet or send the equip-
ment to ISC GmbH
- Set the choke lever to „ "
- Clean the air fi lter
- Contact an authorized customer
service outlet or send the equip-
ment to ISC GmbH
- Clean the spark plug and adjust the
electrode gap, or fi t a new spark
plug
- Contact an authorized customer
service outlet or send the equip-
ment to ISC GmbH
- Use the correct fuel mix (see fuel
mixing table)
- Contact an authorized customer
service outlet or send the equip-
ment to ISC GmbH
25.08.2017 09:50:44 25.08.2017 09:50:44