Storing The Analyzer - Stihl MDG 1 Manual De Instrucciones

English
1.
Make sure the contacts are firmly
–
seated – grounding clips must
engage spark plug's hexagon.
Pull off the boot – turn slightly
–
counterclockwise and remove.
On chain saws with a one-piece
–
shroud, mount the cover and
cutterless chain to reduce the risk of
injury from the rotating fanwheel
and risk of engine damage due to
overheating.
Clip the cover the the front handle –
–
cover must locate against outside of
fan housing.
20
2.
On chain saws on which the clutch
–
drum or spur sprocket is exposed
after connecting the analyzer,
mount the cover and cutterless
chain to reduce the risk of injury.
On chain saws on which the air filter
–
cannot be held in place by the
carburetor box cover after
connecting the analyzer: Secure air
filter with nut (1138 140 9500) to
reduce the risk of engine damage.
Wear personal protective
–
equipment.
Fuel, prepare and start the power
–
tool as described in the instruction
manual.
Never run the engine indoors or in
–
poorly ventilated locations – risk of
fatal injury from breathing toxic
fumes.
Carry out adjustments with extreme
–
care because of the increased risk
of accidents and injury – improper
handling can result in burns and
other serious injuries.
User entries in the computer are not
–
possible during the test with the
engine running – the test run is
finished by shutting off the engine.

Storing the Analyzer

Unplug the power supply unit.
N
Disconnect the diagnostic cable and
N
power cord from the analyzer.
Keep the analyzer, power supply
N
unit, diagnostic cable and power
cord in the case supplied and store
it in a dry, locked and safe location.
Keep it out of the reach of children
N
and other unauthorized persons
and protected from contamination.
MDG 1