Maintenance Plan; Spare Part Order - Zipper Maschinen ZI-KGS210 Manual De Instrucciones

11.1 Changing the saw blade
(Fig. J)
WHEN: Change between saw blades with
different teeth; spare of a damaged, bat-
tered saw blade
ATTENTION: Only use saw blades with:
ü Max. diameter of 210mm
ü Max. thickness of 2,6mm.
ü Max. recommended speed of the saw
blade higher than 5800 rpm.
· Lock the saw aggregate in the highest
position.
· Lock the saw blade by pushing the lev-
er on the engine and turning the saw
blade with the hand till the lever
latches in.
· Swing the saw blade cover up.
· Loosen the screw with the wrench.
· Take out the flanges.
· Take out the saw blade and remove the
valve spacer.
· Remove the inner flanges, clean all
parts with a rag and anoint it easily.
· Mount the new saw blade (backwards
like you removed the old one). Take
care that the teeth point into the
running direction of the engine!
· For precision mitre cuts we recommend
a saw blade with 60 teeth.
11.2 Changing the carbon
brush
What is the carbon brush?
the electrical engine. It provides the
windings of the engine with electricity.
The carbon brush is a wearing part
because it slides on the collector. That s
why there are carbon brushes included in
the delivery. As a result complaints of the
carbon brushes on guarantee are out of
the question. When
doesn t start anymore a battered carbon
brush might be the reason.
Control that by removing the cover cap
(10). Take out the carbon brush. Take
care of the alignment of the brush so that
you are able to mount it correctly. When
the carbon brush is not longer than 4mm
the spring is not able to push the brush
against the collector and the engine does
not run anymore.
It is a part of
your ZI-KGS210
In that case you have to change the
carbon brush. Ensure that you mount it
correctly.
11.3

Maintenance plan

Controls for the upkeep of the machine
Loose or lost Prior to each usage
screws
Damages to any Prior to each usage
part
Condition saw Prior to each usage
blade
Cleaning the After each usage
machine
Draining the After each usage
dust collector
bag
Sharpening the When necessary
saw blade
Changing the When battered or
saw blade damaged
Changing the When shorter than
carbon brush 4mm
11.4 Storage
Never store the machine outdoors!
Storage only at temperatures between
+5° and +40°C!
The air humidity at +40°C must not be
higher than 60%. So store at a dry and
clean place.
11.5 Disposal
DO NOT dispose your ZI-
KGS210 in the
waste! Contact your
authorities for information
about best available disposal
possibilities in your area. Disaggregate the
mitre saw into its components before
disposing its components.
11.6

Spare part order

With original ZIPPER spare parts you use
parts that are attuned to each other and
shorten the installation time and elongate
your machines lifespan.
EN
residual
local