Changing The Saw Blade; Maintenance Plan - Zipper Maschinen ZI-KGS250 Manual De Instrucciones

5 MAINTENANCE
A T T E N T I O N
No cleaning,
maintenance when machine is run-
ning.
Be safe: Disconnect the machine from
the power supply.
The machine is low maintenance and it contains
only a few parts which need some upkeep
works. Damages that decrease the safety of the
machine must be removed immediately!
5.1

Changing the saw blade

WHEN: Change between saw blades with
different teeth; spare of a damaged, bat-
tered saw blade
ATTENTION: Only use saw blades with:
ü Max. diameter of 250mm
ü Max. thickness of 2,8mm.
ü Max. recommended speed of the saw
blade higher than 5000 rpm.
· Lock the saw aggregate in the highest
position.
· Lock the saw blade by pushing the lev-
er on the engine and turning the saw
blade with the hand till the lever
latches in.
· Swing the saw blade cover up.
· Loosen the screw with the wrench.
· Take out the flanges.
· Take out the saw blade and remove the
valve spacer.
· Remove the inner flanges, clean all
parts with a rag and anoint it easily.
· Mount the new saw blade (backwards
like you removed the old one). Take
care that the teeth point into the
running direction of the engine!
· For precision mitre cuts we recommend
a saw blade with 60 teeth.
5.2 Changing the carbon
brush
What is the carbon brush?
the electrical engine. It provides the
windings of the engine with electricity.
The carbon brush is a wearing part
because it slides on the collector. That s
why there are carbon brushes included in
the delivery. As a result complaints of the
carbon brushes on guarantee are out of
upkeep, checks or
It is a part of
the question. When
doesn t start anymore a battered carbon
brush might be the reason.
Control that by removing the cover cap
(10). Take out the carbon brush. Take
care of the alignment of the brush so that
you are able to mount it correctly.
When the carbon
brush is not
longer than 4mm
the spring is not
able to push the
brush against the
collector and the
engine does not run anymore.
In that case you have to change the
carbon brush. Ensure that you mount it
correctly.
5.3

Maintenance plan

Controls for the upkeep of the machine
Loose or lost Prior to each usage
screws
Damages to any Prior to each usage
part
Condition saw Prior to each usage
blade
Cleaning the After each usage
machine
Draining the After each usage
dust collector
bag
Sharpening the When necessary
saw blade
Changing the When battered or
saw blade damaged
Changing the When shorter than
carbon brush 4mm
5.4 Storage
Never store the machine outdoors!
Storage only at temperatures between
+5° and +40°C!
The air humidity at +40°C must not be
higher than 60%. So store the machine at
a dry and clean place.
EN
your ZI-KGS250