Setting Into Operation; Remote Control; Operation Via The Menu - IMG STAGELINE LED-600DX /RGB Manual De Instrucciones

5 Setting into Operation

WARNING Never look directly into the light
source for a longer time, this may
cause eye damage.
Please note that fast changes in light-
ing may trigger epileptic seizures with
photosensitive persons or persons
with epilepsy!
Connect the supplied mains cable to the mains jack
(4) first and then to a socket (230 V~ / 50 Hz). Thus,
the unit is switched on. The display (10) will show
the last adjustment (fig. 1) for a few seconds before
it is extinguished.
6 Operation
The operating mode and the different functions
are selected via a menu (fig. 1) with the buttons
MENU, UP, DOWN and ENTER (6). The supplied
remote control allows to directly select many func-
tions. For operation via a DMX light controller see
chapter 6.7.

6.1 Remote control

1) The remote control is supplied with batteries
inserted. To prevent discharge of the batteries
during storage, an insulating foil is located
between the batteries and the battery contacts.
Prior to the first operation remove the foil from
the battery support on the rear side of the
remote control.
2) When actuating a button, always direct the
remote control towards the LED-600DX / RGB.
There must be no obstacles between the
remote control and the unit.
3) If the range of the remote control decreases,
replace the batteries. For this purpose, push the
small bar with the groove on the rear side of the
remote control to the right and at the same time
remove the battery support.
1.

2.
Two 1.5 V button cells of type L 1130 are re -
quired. When inserting them, make sure that the
positive pole of the front button cell points
upwards and the negative pole of the rear but-
ton cell points upwards.
Removing the battery support
Remove the batteries if the remote control is
not used for a longer period of time so that the
remote control will not be damaged in case the
batteries should leak.
Do not put exhausted batteries into the
household rubbish but take them to a
special waste disposal (e. g. collective
container at your retailer) which is not
harmful to the environment.
4) Overview of the possible functions:
Button
switching on and off all LEDs
input of DMX start address
DMX
(3-digit with numerical keys)
SLAVE switching on slave mode
AUTO 1 / 2 programs 1 and 2 running automatically
adjusting the speed for the programs 1 and 2
SPEED
with the buttons UP / DOWN
SOUND 1 / 2 switching on music control 1 or 2
adjusting the speed for programs 1 and 2 or
UP, DOWN
stroboscope frequency
STROBE switching on and off stroboscope
switching on and off the red, green and blue
R, G, B
LEDs for colour radiator or stroboscope

Functions of the remote control

6.2 Operation via the menu

The adjustments via the menu (fig. 1) are made with
the buttons MENU, UP, DOWN and ENTER (6).
1) Press the button MENU repeatedly until the
indication on the display does not change any
more. Thus, the highest menu level is reached
( fig. 1 on the very left).
2) Select the desired menu item with the button UP
or DOWN.
3) Press the button ENTER. The display now
shows the present adjustment of the selected
menu item.
4) Change the adjustment with the button UP or
DOWN.
5) When submenu items are available, they can be
activated with the button ENTER and their
adjustments can be changed with the button UP
or DOWN.
6) To memorize an adjustment, press the button
ENTER.
7) For further adjustments start with step 1.
If no button has been pressed for a few seconds,
the display will be extinguished. It will light up again
the next time a button is pressed.
Function
GB
11