Operating Elements And Connections; Safety Notes - IMG STAGELINE LED-600DX /RGB Manual De Instrucciones

All operating elements and connections de -
GB
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1 Locking screws for the mounting bracket
2 Mounting bracket
3 Control SENSITIVITY for the sensitivity of re -
sponse in case of music control via the micro-
phone (9)
4 Mains jack for connection to a socket (230 V~ /
50 Hz) via the supplied mains cable
5 Support for the mains fuse
Only replace a blown fuse by one of the same
type.
6 Buttons to select the operating mode and to
change adjustments via the menu
7 XLR chassis mount plug DMX IN: DMX signal
input for connection of a light controller or to the
DMX signal output of another DMX-controlled
unit
8 XLR jack DMX OUT: DMX signal output for con-
nection to the DMX input of another DMX-con-
trolled unit
9 Microphone for music control
10 Display

2 Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING
The unit uses hazardous mains volt-
age. Leave servicing to skilled per-
sonnel only. Inexpert handling may
result in electric shock.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not operate the unit or immediately discon-
nect the mains plug from the mains socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
10
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
G
Never pull the mains cable for disconnecting the
mains plug from the socket, always seize the
plug.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
safely mounted, not correctly connected or oper-
ated, or if it is not repaired in an expert way.
3 Applications
The unit LED-600DX / RGB serves as a strobo-
scope as well as a colour radiator and is suitable for
application on stage, in discotheques etc. As a light
source, 288 extra bright LEDs in red, green and
blue are used.
The unit can be controlled with the supplied
remote control or via a DMX light controller (27, 24,
15, 9, 6 or 3 DMX control channels at option).
4 Mounting
The distance to the illuminated object should be
50 cm as a minimum.
WARNING The unit must be mounted in a safe
.
Fix the unit via the mounting bracket (2), e. g. with
a stable mounting screw or a support for lighting
units (C hook) to a cross bar. To align the unit,
release the two locking screws (1) at the mounting
bracket. Adjust the desired inclination of the unit
and retighten the screws.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
and expert way. If it is installed at
a place where people may walk or
sit under it, it must additionally be
secured (e. g. by a safety rope at the
mounting bracket; fix the safety rope
so that the maximum falling distance
of the unit would not exceed 20 cm).