Changing The Decorative Plate; Connecting The Cooling Device - Dometic GROUP Waeco CoolMatic MDC065 Instrucciones De Uso

MDC065(K), MDC090(K)
➤ Remove the locking plate (fig. 4 4, page 5) and fit it on the opposite side.
➤ Pull the rod downwards and out and put it in the other side.
➤ Fasten the locking hook (fig. 4 3, page 5) back on the rod.
➤ Detach the top and bottom lock holders (fig. 4 5, page 5) on the left side.
➤ Detach the top and bottom door hinges (fig. 4 1, page 5) on the right
side.
➤ Fasten the top and bottom door hinges (fig. 4 1, page 5) to the left side.
➤ Fasten the top and bottom lock holders (fig. 4 5, page 5) to the left side.
6.4

Changing the decorative plate

You can change the decorative plate on your cooling device to improve
the appearance.
This is how to change the decorative plate:
➤ Remove the screws 1 and 3 (fig. 5 1 and 3, page 5).
➤ Remove components 2 and 4 (fig. 5 2 and 4, page 5).
➤ Pull down the old decorative plate out of the door frame.
Caution: there is a risk of injury!
➤ Put the new decorative plate in the door frame.
➤ Fit the components 2 and 4 (fig. 5 2 and 4, page 5) back on the device.
➤ Fasten the screws 1 and 3 (fig. 5 1 and 3, page 5).
6.5

Connecting the cooling device

For the electrical connection you also need the wiring diagram (fig. 6,
page 5).
Cable colours:
No. in
fig. 6,
Meaning
page 5
sw black
rt red
EN
Setting up and connecting the cooling device
29