Installing And Connecting The Refrigerator; Changing The Door Hinge - Dometic GROUP Waeco CoolMatic HDC195 Instrucciones De Montaje Y De Uso

Installing and connecting the refrigerator

7 Installing and connecting the
refrigerator
Please note the following instructions for installation on boats:
D
DANGER!
If the device is powered by the mains, ensure that the power
supply has a residual current circuit breaker.
A
NOTICE!
The device can be tilted sideways up to 30°. When setting up the
refrigerator, note that it must be fastened to take account of this.
If you have any questions regarding installation, consult your
specialist dealer.
7.1

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather
than the right.
➤ Proceed as shown in the illustrations (fig. 2, page 4 to fig. 0, page 12).
7.2 Installing the refrigerator
Observe the following instructions when installing:
 Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the sides, fig. a, page 13).
Key for fig. a, page 13
No. Explanation
1 Cold intake air
2 Hot waste air
3 Spacing above the refrigerator if there is not sufficient air to
circulate above or at the side.
 Leave the device to stand for at least four hours before you connect it to
the power supply so that the oil can flow back into the compressor.
44
HDC195, HDC225
EN