Material Composition And Recyclability; Fuel Cell Model - Operating Instructions - Advance CS7010 Instrucciones De Uso

A - ENGLISH

Material Composition and Recyclability

Type
Aluminum
Electrical / motors / engines - misc
Ferrous metals
Harnesses / cables
Liquids
Plastic - non-recyclable
Plastic - recyclable
Polyethylene
Rubber
CS7010 FUEL CELL MODEL – OPERATING INSTRUCTIONS
Operation:
• Do not turn the fuel cell module off while the machine is in operation! Always turn the machine off fi rst, and then turn the fuel cell
module off.
• For operating, refueling, safety, or service information specifi c to the fuel cell module, refer to the manufacturer's publications.
• The following fuel cell hybrid modules have been evaluated and are approved for use in this equipment:
• Plug_Power, Inc. model 2300 Gen-Drive hybrid fuel cell module
•
• For operating, safety, or service information specifi c to the CS7010, refer to the appropriate Nilfi sk documentation.
Cleaning of Machine:
• FUEL CELL MODULE SHOULD NOT GET WET! Cleaning of the CS7010 should be done in accordance with instructions in the
machine operating manual with the following important note: The fuel cell module should not be subjected to water or solution spray or
indirect contact.
• Do not spray or pour water over the top of the machine as liquid may run between machine panels onto the fuel cell module.
• Keep water spray below the fuel cell compartment.
• Do not spray water or solution into the side grille openings.
Fuel Cell Installation or Removal:
• Follow standard battery installation and removal procedures. Module must be installed or removed using a battery roll-out cart with
minimum capacity rating of 2300 LBS (1050 kg).
• Install the module with the refueling port on the operator side of the machine.
Installation or Removal of Fuel Cell Module User Interface Panel:
• Refer to "Fuel Cell Module User Interface Panel" instruction sheet.
A - 52
INSTRUCTIONS FOR USE
% of machine weight
Petrol / LPG
0.5%
27%
53.8%
1.1%
0.7%
1.5%
0.9%
12%
2.5%
Limitations: The fuel cell module listed above is intended for use in normal warehouse or other moderate-duty
applications. It is intended for indoor use only. It may not be suitable for severe-duty applications such as rough
surface cleaning/sweeping or severe inclines.
CS7010 - 56091206
% of machine weight % of machine weight
Diesel
0.5%
29.3%
51%
1.2%
0.7%
1.8%
0.7%
12.3%
2.5%
% recyclable
Battery
0.3% 88%
50.1% 95%
35.2% 95%
0.9% 74%
0.9% 95%
1.1% 0%
0.4% 91%
9.2% 100%
1.9% 60%
4/2017