ASBER TECH-500 Serie Manual De Instrucciones página 45

asberprofessional.com
Before switching on the machine, check the following:
To switch on the machine just press the ON-OFF button once for 1.5 seconds. (See figure 8).
14.1.2.1 Filling and heating.
When the machine is switched on, it will start to fill. First the rinse boiler is filled and then the wash
tub. The filling process may last a few minutes. Once the wash tub is full, the boiler starts to heat up
and when it is hot, the tub is heated. Although it is possible to start the wash process, this is not rec-
ommended as the water inside the machine is not yet at the ideal temperature. When the machine
reaches the ideal washing temperature, the dishwashing process can be started. See the temperature
on the corresponding displays. The temperature in the boiler should be between 82-90 ⁰C and in the
tank between 57-62 ⁰C (see figure).
ASBER recommends that the water in the dishwasher is changed every 40/50 washes or twice a day.
The machine you have purchased is fitted with a safety thermostat on the boiler, so that, if the main
thermostat fails, the safety thermostat is able to disconnect the boiler heating.
44
asberprofessional.com
The mains switch must be on.
The water stop cock must be open.
There must be water in the mains network.
The corresponding filters must be in place.
The overflow should be mounted in place.
Figure 8 Switching on the machine
Figure 9 Temperature display
The door must be closed for the machine to start filling. For safety
reasons, if the door is open, the machine will not fill.
During the first heating of the day, the boiler may reach a higher
temperature than that mentioned above due to heating inertia. This is
normal. If pressurised steam is observed coming out of the rinse
branch nozzles, while the boiler is heating, the technical service should
be notified.
ENGLISH