Faults, Alarms And Breakdowns; Operating Faults - ASBER TECH-500 Serie Manual De Instrucciones

Lavavajillas de apertura frontal
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
asberprofessional.com
The steps to be followed in the event of a fault or operating error are described below. The possible causes
and possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve the
problem, please contact the technical service.
 

15.1 Operating faults

FAULT
 
The machine does not come 
on 
The  machine  does  not  fill 
with water. 
Unsatisfactory wash 
Dishes and kitchenware are 
not dry 
Scratches  or  stains  on  Too much rinse aid. 
 
 
49
asberprofessional.com
 

15. FAULTS, ALARMS AND BREAKDOWNS

Do not handle electrical components as there is a risk of death as the 
POSSIBLE CAUSE
There  is  no  power 
supply. 
The fuses have blown. 
Main switch open. 
Water  entrance  valve 
closed. 
Rinse nozzles blocked. 
Solenoid  valve  filter 
blocked. 
Pressure  switch  bro‐
ken 
Door  is  not  closed 
properly 
Wash 
obstructed. 
Shortage of detergent.  Call the technical service to reset the dispenser. 
Dirty filters. 
Presence of foam 
Temperature  of  tub 
lower than 50 ⁰C / 122 
⁰F. 
Length  of  cycle  too 
short  for  level  of  dirt 
on dishes. 
Water too dirty. 
There is no rinse aid 
Insufficient rinse aid. 
Dishes 
dishwasher  for  too 
long. 
Rinse 
lower than 80 ⁰C / 176 
⁰F 
 
components are live.
SOLUTION
 
 Check  whether  the  magneto‐thermal  circuit 
breaker has been triggered. 
Call the technical service to analyse the reason why. 
Close switch. 
Open the water valve.  
Clean  nozzles  and  check  branches  for  build‐up  of 
lime. 
Call the technical service to clean the filter. 
Call the technical service to replace the pressostat. 
Close the door properly. 
distributors 
Clean distributors thoroughly. 
Clean the filters thoroughly. 
Unsuitable detergent or too much rinse aid. Call the 
technical  service  to  supply  correct  detergent  or  to 
reset rinse aid dispenser. 
Thermostat faulty or incorrectly set. Call the techni‐
cal service to repair it. 
Select a longer cycle. 
Drain the wash tub and fill with clean water. 
Fill the rinse aid container. 
Call technical service to adjust dispenser. 
left 
inside 
When  the  dishwasher  finishes,  remove  the  basket 
from the machine and allow to dry naturally. 
temperature 
Call technical service to analyse problem. 
Call technical service to adjust rinse aid dispenser. 
 
ENGLISH
 
 
 

Publicidad

Tabla de contenido
loading

Tabla de contenido