Disposal - Beurer BM 77 Manual De Instrucciones

The cuff was
E1
not attached
correctly, the cuff
line has not been
inserted properly,
or inflation takes
longer than 15
seconds.
The inflation pres-
E2
sure is higher than
300 mmHg.
An error occurred
E3
when saving the
measurement.
Please wait one minute
and repeat the measure-
ment, making sure to
observe the information
in chapter "Attaching the
cuff".
Please also check
whether the cuff line has
been inserted properly
and ensure that neither
your arm nor other heavy
objects are pressing on
the line, and that the line
is not bent.
Please take another
measurement to check
whether the cuff can be
correctly inflated.
Make sure that neither
your arm nor other heavy
objects are pressing on
the line, and that the line
is not bent.
Please wait one minute
and repeat the measure-
ment.
Ensure that you do not
speak or move during the
measurement.
Unable to transfer
E4
the data via Blue­
tooth .
®
Unable to transfer
PCEr
the data to the
PC.
The batteries are
almost empty.

11. Disposal

Repairing and disposing of the device
• Do not repair or adjust the device yourself. Proper operation
can no longer be guaranteed in this case.
• Do not open the device. Failure to comply will invalidate the
warranty.
• Repairs must only be carried out by Customer Services or
authorised retailers. Before making a claim, please check the
batteries first and replace them if necessary.
• For environmental reasons, do not dispose of the
device in household waste at the end of its service
life. Dispose of the device at a suitable local collection
or recycling point in your country. Dispose of the device in
accordance with EC Directive – WEEE (Waste Electrical and
Electronic Equipment). If you have any questions, please
contact the local authorities responsible for waste disposal.
40
Please observe the infor-
mation in chapter "Trans-
fer of measurements via
Bluetooth ".
®
Please observe the infor-
mation in chapter "Trans-
fer of measurements via
USB".
Insert new batteries into
the device.