Safety Instructions For The Transmitter Batteries; Intended Use; Switching Off - Multiplex SMART SX FLEXX Manual De Instrucciones

Safety instructions
2.2
2.3
SMART SX FLEXX

Safety instructions for the transmitter batteries

Remove the transmitter batteries if the device is not used for an extended period of
time, since the batteries could otherwise leak and cause damage.
Always insert new batteries after an extended period of disuse.
Stop operating the model as soon as the voltage monitor emits a warning
sound. Replace the batteries with new ones.
Never attempt to charge non-rechargeable batteries; there is a risk of explosion.

Intended use

Always follow the switching on/off sequence in order to avoid any uncontrolled,
dangerous start-up of the drive:
Switching on
1. Transmitter ON
2. Connect the drive battery or switch the receive system to ON

Switching off

1. Disconnect the drive battery or switch the receive system to OFF
2. Transmitter OFF
Assemble the model carefully

Do not strain or bend cables; protect them against rotating parts.

Avoid unnecessarily long or superfluous servo extension cables.

Use cables with sufficient cross-section.

Take care to maintain sufficient distance between cables carrying heavy
currents (e.g. electric drive) and the RC system. Especially the cables between
brushless electric motors and their actuators must be kept as short as possible
(guide value: max. 10 to 15 cm).
Page 51