Connecting Digital Components - Sony SDP-EP9ES Manual De Instrucciones

Getting Started
If you have an additional surround amplifier with
pre out terminals (such as the Sony TA-E2000ESD)
You can connect it to this unit's BYPASS INPUT jacks.
The signals from the connected amplifier will be output
without alteration from this unit's OUTPUT jacks when
you select BYPASS (see page 11 for details).
If you have an additional centre speaker or active
sub woofer
Connect the other CENTER OUTPUT terminal to the
input on the amplifier for your other centre speaker.
Connect the other WOOFER OUTPUT terminal to the
input terminal on the active woofer.
TA-VA8ES
5.1 INPUT
FRONT REAR
CENTER
WOOFER

Connecting digital components

You can connect the digital output jacks of a DVD
player, DAT/MD deck, CD player (etc.) to the
surround processor's digital input jacks (DIGITAL
INPUT 1~4).
You can also connect the AC-3 RF output terminal of
an LD player to the surround processor's AC-3 RF
INPUT terminal.
You can connect the surround processor's digital
output jack (DIGITAL OUTPUT) to a DAT/MD deck.
What cords will I need?
• Optical digital connecting cord (not supplied)
• Coaxial digital connecting cord (not supplied)
6 GB
Amplifier for
SDP-EP9ES centre speaker
OUTPUT
FRONT REAR CENTER ç
L L
Ç
R R WOOFER
ç
Ç
Ç
Active Woofer
Ç
Hookups
The arrow ç
DVD player
Be sure to connect the DVD player's digital output to
one of the surround processor's DIGITAL INPUT 1~4
jacks.
DVD player
DIGITAL
OUT
If your DVD player has a COAXIAL DIGITAL OUTPUT, we
recommend connecting the DVD player's COAXIAL
DIGITAL INPUT to the this unit's DIGITAL INPUT 4
INPUT (COAXIAL IN) instead of making the optical connection
shown above.
INPUT
LD player
Be sure to connect the LD player's AC-3 RF output to
the surround processor's AC-3 RF INPUT jacks.
LD player
AC-3
RF
OUT
If your LD player has an optical digital output, connect it to
one of the DIGITAL INPUT 1~3 jacks on this unit.
This connection can be used together with the AC-3 RF
connection.
CD player
CD player
DIGITAL
OUT
DAT/MD deck
DAT/MD deck
DIGITAL
IN OUT
Note
This unit is only compatible with digital components using
32 kHz/44.1 kHz/48 kHz sampling frequencies. It is not
compatible with 96 kHz.
indicates signal flow.
Surround processor
OUTPUT INPUT
DIGITAL DIGITAL DIGITAL DIGITAL
4 3 2
Surround processor
OUTPUT INPUT
DIGITAL DIGITAL DIGITAL DIGITAL
4 3 2
Surround processor
OUTPUT INPUT
DIGITAL DIGITAL DIGITAL DIGITAL
4 3 2
Surround processor
OUTPUT INPUT
DIGITAL DIGITAL DIGITAL DIGITAL
4 3 2
DIGITAL AC-3
1 RF
DIGITAL AC-3
1 RF
DIGITAL AC-3
1 RF
DIGITAL AC-3
1 RF