Hayward ColorLogic 320 Manual Del Usuario página 14

Installation Location
When installed in water, the ColorLogic
of the lens not less than 10 cm below the normal water level of the pool except when the fixture is installed in an area of the
swimming pool that is not used for swimming. Select a location for the light fixture(s) that will give optimum light dispersion
for the pool or spa design. Be sure to consider the direction of emitted light and take care not to point lights directly at the
house or outdoor living spaces.
Assembling the PVC wall fitting
Apply PTFE tape to thread. Screw the reducer into the adapter and hand tighten. Using a tool, tighten one more full turn.
Additional tightening is unnecessary and could break the adapter.
Before solvent cementing the adapter to the wall fitting, do not forget to check that the length of the wall fitting is suitable
for your installation.
If the wall fitting needs to be lengthened, add a length of PVC tube and a PVC sleeve (not supplied).
Installing the wall fitting
The configuration in which the PVC wall fitting is installed depends on the type of pool (concrete or vinyl liner).
- Installation of concrete version: use the flange and screws + cover. No need to use a gasket.
- Installation of vinyl version: use the flange and screws + cover + 2 gaskets.
Electrical conduit provided
Page 5 of 8
320 LED light must be installed in a wall or on a floor of the pool or spa with the top
®
Apply PTFE tape
USE ONLY GENUINE REPLACEMENT PARTS
ColorLogic
10 cm min.
Solvent cement the adapter
after having checked the
length of the wall fitting
320
®
Complete wall fitting
Rev. A