Hayward ColorLogic 320 Manual Del Usuario página 17

Troubleshooting
If you have a problem with your Hayward ColorLogic 320 light, please try the following tips before calling for service:
®
PROBLEM: ColorLogic Light will not advance to the next program when it is power-cycled (turned "off" and then back "on").
SOLUTION: Do not power-cycle the switch too rapidly. Leave it off for at least 1 second before turning it back on.
PROBLEM: ColorLogic Light goes to white whenever it is power-cycled (turned "off" and then back "on").
SOLUTION: Be sure that you power-cycle the light for less than 10 seconds.
PROBLEM: Multiple ColorLogic Lights are not correctly synchronized.
SOLUTION: Refer to "Light Synchronization". Follow the steps in these instructions to re-synchronize the lights.
PROBLEM: Light will not come on.
SOLUTION: Check input power to transformer and then light. Check ground fault and reset if necessary.
PROBLEM: Light will not come on or light cycles on and off.
SOLUTION: Depending on cord length and operating voltage, automatic thermal switch may be cycling due to excessive air/
pool water temperatures (over 40°c). For ColorLogic lights, temporarily switch to a cooler color (Deep Blue Sea, Royal Blue,
etc.) until air/water temperatures cool off.
USE ONLY GENUINE REPLACEMENT PARTS
Page 8 of 8 Rev. A
ColorLogic 320
®