Hayward ColorLogic 320 Manual Del Usuario página 15

Install the ColorLogic LED Light® 320 in the PVC wall fitting.
Once the PVC wall fitting is secured in the pool wall, follow these steps to secure the light:
1) Run the cord of the ColorLogic LED Light® 320 through the conduit to the junction box.
2) Fully insert the ColorLogic LED Light ® 320 into the wall fitting. Insert the supplied hex nut tool into the 3 radial slots on
the light face as shown in the diagram.
3) Slide the ring tool over the nut tool and insert the tabs into the light face. Hold the nut tool with a wrench while rotating
the ring tool clockwise. Hand tighten the ring tool until snug. Do not overtighten.
Page 6 of 8
USE ONLY GENUINE REPLACEMENT PARTS
ColorLogic
Inside pool
320
®
Rev. A