Cleaning And Maintenance; Scope Of Delivery - HSM SECURIO P 44 Instrucciones De Servicio

pull the paper out of the paper slit and feed it
back in again.
PAPERcontrol
The measuring of the paper thickness is regu-
larly calibrated: the LED fl ashes for a short time
after 400 seconds.

6 Cleaning and maintenance

WARNING
Dangerous mains voltage!
Switch off the shredder and pull out
the mains plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must
enter the equipment.
Strip cut only:
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer.
Only use HSM special
lubricating oil for the cutting
unit to do this:
• Spray special cutting apparatus oil through
the paper feed opening along the entire width
on to the cutting rollers.
• Let the cutting unit run in the permanent
mode for about 10 seconds without any pa-
per.
 Paper dust and particles are shaken off.
12/2014
7 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.

8 Scope of delivery

• Paper shredder, ready for connection, in car-
ton packing, carton on pallet, tied with strap-
ping tape
• 5 bags for shredded material
• Special cutting block oil (cross cut)
• Operating instructions
Acces so ries
• 25 bags for shredded material,
order No.: 1.452.995.000
• Special cutting block oil 250 ml,
order No.: 1.235.997.403
See page 180 for our customer service ad-
dresses.
SECURIO P 44
english
17