5 Operation
5.1 Displaying the operating instructions
en
1.
Press the "Home" button for 5 seconds.
The operating instructions will be shown in the right context in the display. You can then browse through the
complete operating instructions.
2.
The operating instructions can also be displayed by way of the settings menu in the main menu by pressing the
Help function button.
3.
To close the operating instructions, press the Back function button.
5.2 Basic functions
The function buttons can be used to select the available functions.
The 4-way controller can be used to shift the focus, change parameter values or, depending on the setting, shift the
cross hairs or change the layer thickness/depth, etc.
The Ok confirmation button can be used to select the object in focus or to start data processing.
5.3 Project and data management
Ferroscan and X-Scan data can be managed within a project at the same time.
5.3.1 Managing PS 1000 X-Scan projects and data 4
The "Projects" submenu provides access to functions that let you manage projects, display and analyze recorded
scans and import new data from the PS 1000 X-Scan.
1.
Import the data (projects / scans) directly from the PS 1000 X-Scan using the PSA 50/51 data transfer cable.
2.
Select the Projects function from the main menu.
3.
Select the desired project. The active project can be identified by its "dog ear" at top right.
NOTE The currently active project can also be accessed directly from the main menu by way of the Openproject
function button.
4.
Select the desired scan.
The scan is then displayed.
5.
Set the control behavior of the 4-way controller using the function button at top left.
6.
Use the function button to set the display mode to "2D" or "3D".
8