Fitting The Loudspeaker - Focal 300 Serie Manual De Uso

300 SERIES
U s e r m a n u a l
Existing installation
• Before installing the loudspeakers, ensure that the intended positions in the ceiling/wall are free of any
obstruction such as air vents or any cables that may interfere with the installation. Use the appropriate
tools to help you determine suitable locations.
• Make sure that there is enough space inside the ceiling/wall to install the product.
• Trace around the cut-out template provided, onto the existing ceiling/wall. Cut along the traced line with
a tool suitable to create an opening in the ceiling/wall (fig. A1, A2 / B1, B2 / C1, C2).
New installation
• Use the optional specific mounting kit
• Wire up the speakers before installing them

Fitting the loudspeaker

Products from the 300 Series range include a loudspeaker and a magnetic grille.
The 300ICLCR5 loudspeaker is supplied with adapters (located close to the corners) allowing it to suit
different ceiling depths (12 to 54mm).
Fitting products from the 300 Series range does not require any tools, thanks to the Easy Quick Install
system!
300IW6/300IWLCR6
1. Lift the mounting feet (fig. A3 / B3)
2. Connect the pre-stripped loudspeaker wire to the loudspeaker's spring-loaded terminals. It is essential
that the connection polarity for each loudspeaker is correct: the cable connected to the "+" terminal on
the amplifier must be connected to the red terminal on the loudspeaker. Likewise, the cable connected to
the "-" cable on the amplifier must be connected to the black terminal.
3. Insert the product into the wall or ceiling by pressing on each side of the loudspeaker to ensure it is in
place (fig. A5 / B5).
4. If required, adjust the treble and mid-range according to the room's acoustics (fig. A7 / B7).
300IWLCR6 : If used as the central loudspeaker, remove the 4 screws from the mid-range and tweeter
support, turn the support 90° to line up the tweeter with the "CENTER" marking (fig. B6). Tighten the 4
screws.
300IW6 : Point the tweeter towards the listening area (fig. A7).
5. The 300 Series loudspeakers are supplied with an opacifying acoustic cloth. Remove the protective film
then attach the cloth to the grille. However, the best audio performance will be obtained without the
opacifying cloth.
6. The grille can now be fitted. The grille is held onto the mounting frame magnetically, which means you only
need to align it with the edge of the mounting frame. (fig. A8 / B8)
21