Using The Steam Tray And Steam Rack; Baking - Samsung NE59N6650 Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating the oven

Using the steam tray and steam rack

30 English
NE59N6650W_DG68-01049A-01_EN+MES+CFR.indb 30
Placing the steam rack
1.
Place the end of the steam rack on the
support of the second rack position.
2.
Tilt the front end up and push the rack
in.
Placing the steam tray
1.
Place the end of the steam tray on the
support.
2.
Push the steam tray in.
Removing the steam tray
1.
Pull the Steam Tray out until it stops.
2.
Lift up the front of the steam tray, and
then pull it out.
Removing the steam rack
1.
Pull the Steam Rack straight out until it
stops.
2.
Lift up the front of the rack, and then
pull it out.

Baking

The oven can be programmed to bake at any temperature from 175 °F to 550 °F.
Baking temperature and time will vary depending on the ingredients and the size
and shape of the baking pan used. Dark or nonstick coatings may cook faster with
more browning.
How to set the temperature
1.
Press Bake. The default temperature is 350 °F.
2.
Enter the temperature you want on the number pad, eg. 3, 7, 5.
3.
Press START/SET. The temperature display will start to change once the oven
temperature reaches 175 °F.
4.
If you want to cancel baking or if baking has finished, press OVEN OFF.
Place food in the oven after preheating if the recipe calls for it. Preheating
is very important for good results when baking cakes, cookies, pastry, and
breads. After the oven has reached the desired temperature, the range will
beep several times.
NOTE
For performance reasons, the convection fan may be turned on or off during
baking.
If you are using an oven thermometer in the oven cavity, the temperature
registered by the thermometer may differ from the actual set oven
temperature.
How to adjust the temperature while cooking
1.
Press Temp.. The display will show the present temperature, eg. 375 °F.
2.
Enter the temperature you want,
eg. 425 °F, using the number pad.
3.
Complete the entry by pressing START/SET.
7/10/2018 12:10:15 PM

Publicidad

Tabla de contenido
loading

Tabla de contenido