Dust Extraction; Working With The Machine - Festool KA 65 Manual De Instrucciones

Purging process is carried out
2
190 °C
Adhesive nozzles are open, pres-
sure has built in the adhesive car-
tridges. Display of the current
status.
Cooling mode
180 °C
The machine reduces the tem-
perature in cooling mode and
then switches off. Cooling mode
is activated when:
– on/off switch [1-8] is pressed <
1 s
– no controls are actuated for
more than 15 minutes
The machine is switched on again
by pressing the start button [1-1]
or the on/off switch [1-8].
Fault symbol
Troubleshooting (chapter 12).
0
**
Automatic calculation of currently detected edge
height
7.6

Dust extraction

CAUTION
Vapours emitted during the glueing process!
Ensure there is good ventilation.

Use an extractor.

Always observe national regulations.

An extractor hose with a diameter of 27 mm can be
attached to the extractor connector [1-6].
8

Working with the machine

WARNING
High temperatures on the heating unit and adhe-
sive nozzle!
Risk of burns when touched
Wear suitable protective gloves.

Always hold the machine by the insulated han-

dles [1-3], [1-16]!
WARNING
Moving workpiece!
Risk of injury from sliding workpiece
Always secure the workpiece in such a manner

that it cannot move.
CAUTION
Hardened PU adhesive has settled inside the ma-
chine.
Risk of damage to the machine – loss of warranty
Clean the system no more than six hours after

using PU adhesive (see section 8.5).
8.1 Glueing the edge band
Cut the edge band down to size, leaving an al-

lowance of approximately 10 cm.
Switch on the machine [1-8].

Select the temperature setting [1-7].

Display [1-20] lights up red = actual and set-
point temperature are displayed. Machine is not
yet ready for operation.
Display [1-20] lights up green = operating tem-
perature reached. Setpoint temperature is dis-
played.
Machine is now ready for operation.
Adjust the relevant settings (chapter 7).

Press the start button [1-1] once.

Edge inlet mechanism starts up.
Guide the edge band into the edge inlet within 20

seconds [1-11].
The time remaining is shown on the display [1-
20] .
The edge band is drawn in automatically up to
the light barrier [3-4] .
Inlet stops.
Position the machine on the workpiece [4-1]

approx. 2 cm away from the contact roller [4-3]
with reference to the start marking [4-2] [4].
The start marking [4-2] and edge of the work-
piece must be flush with one another.
Press the start button [1-1] again.

Inlet starts.
Wait until the edge band with adhesive is visible.
Push the machine down onto the workpiece and

guide lengthways from right to left [5]. Exert
pressure on the support base and against the
KA 65 GB
19