After Finishing Work; Service And Maintenance - Festool KA 65 Manual De Instrucciones

8.5 Purging to remove PU adhesive from the
machine
Directly after completing the work, or six
hours afterwards at the latest, purge the sys-
tem in order to prevent a chemical reaction
from taking place within the system.
Switch the machine to purge mode (see section

8.3).
Set the temperature to 140° C.

Insert a purging cartridge and purge the entire

system.
Reset the temperature to 190° C.

Purge the system using at least three EVA adhe-

sive cartridges until all the purging material has
been removed from the machine and the system
is completely full of EVA adhesive.
8.6

After finishing work

Switch off the machine and allow to cool.

If necessary, clean the adhesive nozzle [1-14]

carefully using a strip of wood. Do not use me-
tallic or highly flammable materials!
Remove the drip catcher [1-13] and turn upside

down to clean.
Observe the following instructions:
– Allow the machine to cool completely before
placing in a Systainer.
– Do not transport the machine in purging mode
otherwise adhesive may escape.
9

Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the

socket before performing maintenance work on
the machine!
All maintenance and repair work which requires

the motor housing to be opened must only be
carried out by an authorised service workshop.
Always keep the machine clean. Read chapter

8.3 and 8.6!
If the plastic sliding plate [2-1] (wear part) is

damaged, the plate can be replaced by loosen-
ing the 4 screws underneath the support base
[1-17].
Keep the ventilation slits on the electric power

tool clean and unobstructed to guarantee ade-
quate cooling.
Store in a cool location that is free of dust.

Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/service
5
3
2
1
10 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European
Directive on waste electrical and electronic equip-
ment and implementation in national law, used
electric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Information on REACh: www.festool.com/reach
KA 65 GB
21