en
Problem
Loss of pressure
Steam release button activated during a
during ironing.
long period of time.
Calc´n clean pilot
Boiler must be rinsed
lamp (9) lights up
continuosly
Water leakage
Drainage plug located at the bottom of the
from the boiler
appliance is loose.
Pressure gauge (6)
Pressure inside the boiler is high
reaches red area
frequently
Warranty conditions
The terms of the guarantee for this appliance are in
accordance with that stated by our representative
for the country in which it is sold. The details of
these conditions can be obtained from the retailer
from whom the appliance was purchased. The
purchase receipt must be presented when making
any claims against the terms of this guarantee.
You can download this manual from the local homepages of Bosch.
1
Possible causes
Advice on disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
Your local town council can give you information
about how to dispose of obsolete appliances.
Solution
Use the steam release button (17) with
intervals. This improves the ironing
result as the textiles will be dried and
stay smooth better.
Proceed to rinse the boiler according
to the instructions.
Then, switch the station off twice,
keeping it off during at least 30
seconds each time
Tighten up boiler drainage plug with
a coin
Switch the station off, and have it
checked by a technical service centre
This
appliance
is
accordance with European Directive
2002/96/EG
concerning
electrical and electronic appliances
(waste
electrical
and
equipment WEEE).
labelled
in
used
electronic