Bartscher 110801 Manual Del Usario página 36

Digital temperature regulator
The default temperature is set at the factory and corresponds to an internal operating
temperature of 0 ° C – 10 °C.
During normal operation the display will show the temperature as detected by the sensor.
Active functions will also be shown (table 1), while three buttons can activate/deactivate
some functions (table 2).
Indicators
Diode Function
➀
Compressor
➁
Ventilator
➂
Defrost
Auxiliary
➃
output
➄
RTC clock
➅
Alarm
Digital
➆
indicators
- 32 -
Normal operating mode
ON OFF
On Off
On Off
On Off
Active Inactive
output output
RTC RTC
available, unavailable or
active inactive
(tEN=1) and (tEN=0)
at least 1 or no
programmed programmed
time cycle time cycle
Alarm active No active
alarm
Composed of three segments with decimal point
and division - 199...999. See parameters /4, /5, /6
for sensor reading indicator. Values in ° C/° F and
decimal point.
Tab. 1
Start-
up
FLASHING
Activation ON
Activation ON
Activation ON
-
ON
ON
- ON