Directions For Use; Important - Microlife FR 1DM1 Manual Del Usuario

6. Directions for Use

1. Press the O/I button. The LCD is activated
to show all segments for 2 seconds.
2. The last measurement reading will be
shown on the display automatically for
3 seconds with the «M» icon.
3. When the °C or °F icon is flashing, a beep
sound is heard and the thermometer is
ready for measurement.
4. Place the probe gently onto the area
approximately 1cm above the center of
the eyebrow. If the eyebrow area is
covered with hair, sweat or dirt, please
remove the obstacle beforehand to
improve the reading accuracy.
5. Press the START button once and release
it. Start to move the instrument steadily
from 1cm above the center of the eyebrow
to 1cm above the tail of the eyebrow area. A long beep
sound will emit after 3 seconds to acknowledge the comple-
tion of measurement. If the probe movement is too slow to
reach the tail of the eyebrow before the long beeb sound
heard, repeat the measurement as above from point 4, but
simply move the probe a little quicker this time.
6. Read the recorded temperature from the
LCD display.

IMPORTANT:

• Patients should stay in steady - state room condition for at
least 30 minutes.
• Don't take a measurement while or immediately after
nursing a baby.
• Don't use the forehead thermometer in high humidity
environments.
• Patients should not drink, eat, or exercise before/while
taking the measurement.
• Before placing the thermometer probe onto the measure-
ment area, remove dirt, hair, or sweat.
6