FALMEC Lumen Isola Serie Manual De Instrucciones página 23

OPERATION
WHEN SHOULD THE HOOD BE SWITCHED ON AND OFF?
Switch on the hood at least one minute before starting to cook: this enhances the airlow to convey fumes and vapours towards the suction surface.
After cooking, leave the hood operating until complete extraction of all vapours and odours. If required, for versions with electronic push button
control panel, by means of the Timer function, it is possible to set hood auto switch-of after 15 minutes of operation.
WHICH SPEED IS TO BE SELECTED?
The irst speed is a low consumption energy-saving way of keeping the air clean, the second speed is used in normal conditions, and the third
speed is used when there are strong odours and vapours.
WHEN SHOULD THE FILTERS BE WASHED OR REPLACED?
The hood is assembled with two diferent types of ilters: metal ones (washable) and active carbon ones (non-washable). The former must be cleaned eve-
ry 30 hours of use (for versions with electronic push button control panel, the ixed red light
replaced every 3-4 months, depending on the use of the hood. For further information, please read the chapter regarding "Maintenance" on page 24.
USE OF ELECTRONIC PUSH BUTTON CONTROL PANEL
Timer/Filters alarm
Pressing the key with the motor active at any speed activates the Timer function: this function determines the auto switch-of of the
hood after 15 minutes of operation. Activation of the function is signalled by a RED lashing light.
With the Timer function active, the hood can still be switched of by the user at any time by pressing the key
automatically disabled and the RED light will turn of. Should the speed be changed with the Timer function active, the latter will be
automatically disabled.
On the other hand, ignition of the ixed RED light indicates a grease ilter alarm: this alarm notiies that it is time to wash the metal anti-
grease ilters (the alarm is triggered after approximately 30 hours of use). After cleaning the ilters, disable the alarm and reset the counters
by keeping the key pressed for 3 seconds.
To disassemble and assemble the anti-grease metal ilters, refer to the instructions on drawing
Mode button (ON/OFF)
Pressing the key switches on (or of ) the hood motor: it starts at the previously selected speed prior to switching it of (desired speed
function). Should you wish to use a diferent speed, set if by using the + and - keys.
Button +
By pressing the key, the motor speed increases. Speeds 1, 2 and 3 are displayed by the number of LEDs switched on, excluding the light and timer LEDs.
The + key in the version with 4 speeds has an intermittent light: the 4th speed or intensity is timed and after approximately 7 minutes the motor au-
tomatically switches to 3rd speed.
Button -
By pressing the key, the motor speed reduces. Speeds 1, 2 and 3 are displayed by the number of LEDs switched on, excluding the light and timer LEDs.
Light button
ON: light on (lit button)OFF: light of
LIGHTING
The hood has luorescent lamp lighting.
If the lamp ever needs to be replaced:
disconnect the appliance from the electrical mains power supply by unplugging it or turning of the main switch;
•
Phase
• remove the covering element (N) (Fig.
• take out the blown luorescent tube (M) (Fig.
• put in a new luorescent lamp by performing, in reverse order, the operations described in Fig.
The new luorescent lamp must be identical to the old one!
• put the covering element back in (N) performing, in reverse order, the operations described in Fig.
• connect the appliance back up to the electrical power mains.
Q
page 10
and );
1 2
and );
3 4
indicates that they need to be washed), the latter are to be
and
3
1
23
: the function will be
O
on page 10.
;
4
and ;
2