Connecting A Battery; Disconnecting A Battery; Display And Keyboard - MicroPower MTM-HF 3200 Instrucciones De Uso

Charging
WARNING!
In the case of danger, disconnect the mains voltage by pulling out the
plug from the wall socket.

Connecting a battery

1. Check the wiring and adapter to ensure that there is no visible damage.
2. Connect the battery to the battery charger.
3. The battery charger automatically starts charging when the battery is
connected.
4. The current charging phase is displayed with the charging symbols on the
panel.
5. A green battery symbol is displayed when the battery is full charged. The
battery goes over to maintenance charging.
Note!
The green battery symbol will not light immediately if a fully charged battery is
connected. This time can vary between 0 and 2 hours.

Disconnecting a battery

1. Turn off the battery charger by pressing the 0 on the keyboard.
CAUTION!
The battery charger should be turned off when disconnecting the battery. If
the battery is disconnected during an ongoing charge, the contacts in the
charging glove will be damaged and spark formation can occur causing a
hydrogen gas explosion
2. Disconnect the battery from the battery charger.
CAUTION!
Disconnect the battery immediately after turning off the battery charger.
Charging is resumed after 30 seconds if the battery is still connected.

Display and keyboard

Normally, the display shows the charger's current and voltage as well as the time
during an ongoing charging process.
Data and measurement test results are stored during charging. These are accessible
for service purposes via a menu system. The menu system is described in the
Technical Desciption.
8
English