Battery Specifications; Initial Start-Up (No Load) - Briggs & Stratton 35000 Serie Manual De Instrucciones

Battery
WARNING Battery posts, terminals and related
accessories contain lead and lead compounds - chemicals
known to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
The installer must supply and install a valve-regulated
rechargeable starting battery. The starting battery MUST
conform to the specifications shown in this chart.

Battery Specifications

Volts 12 Volt DC
Amps (MIN) 650 CCA (cold cranking amps)
Type VRLA (Valve Regulated Lead Acid)
Terminal Hardware Post
Dimensions (MAX):
Width 7.5 inches (191 mm)
Length 11.25 inches (286 mm)
Height 10.0 inches (254 mm)
Install the battery as described in Servicing the Battery in
the Maintenance section of the operator's manual. Always
make sure the NEGATIVE cable is connected last.

Initial Start-up (No Load)

Unit has been set-up for NG or LP vapor operation at the
factory. Fuel conversion, if needed, must be completed prior
to performing these steps.
Before operating the generator or placing it into service,
inspect the entire installation carefully. Then begin testing the
system without any electrical loads connected, as follows:
1. Connect an accurate AC voltmeter and a frequency
meter to check generator output at load side of
circuit breaker.
2. Set generator's circuit breaker to its ON
(closed) position.
3. Confirm 15 Amp fuse is installed in system
control panel.
4. Set generator's system switch to AUTO.
5. Push and hold MANUAL OVER-RIDE button on control
panel for about six seconds. Engine will start.
When the generator is started for the very first time, it
will require that air in the gaseous fuel lines be purged.
This may take a few minutes.
6. Listen for unusual noises, vibration or other indications
of abnormal operation. Check for oil or coolant leaks
while engine runs.
7. Using a phase rotation meter, verify generator output at
load side of circuit breaker matches utility power.
8. Let engine warm up for about five minutes to allow
internal temperatures to stabilize.
9. No-load voltage should be 238 - 244 Volts* for 240V
generators. Frequency should be 59.8 - 60.2 Hz.
If AC voltage is outside these ranges, perform the
generator adjustment, Steps 12 and 13 below.
10. Check generator output between each of the
generator connection lugs and the neutral lug. In all
cases, voltage reading should be 136-142 for 240V
generators.
DO NOT proceed until you are certain that generator AC
voltage is correct and within the stated limits. Generator
frequency is fixed and not adjustable.
11. If voltage and frequency values are correct, proceed to
step 13.
12. Connect voltmeter as described in step 1 above.
13. While observing voltmeter, adjust alternator voltage
control (A) for 240 volts for 240V. DO NOT adjust either
of the other alternator controls.
14. Push and hold MANUAL OVER-RIDE button on control
panel until engine stops.
A
15. Install alternator circuit breaker enclosure cover.
* Refer to the table below to determine proper no-load
voltage.
Voltage
3Phase Wye 120/208
3Phase Wye 139/240
3Phase Delta 120/240
3Phase Wye 240/216
3Phase Wye 277/480
3Phase Wye 332/575
No-Load Voltage
MIN MAX
206 210
238 242
238 242
412 420
475 485
569 581
21