Fein WSG8-115 Instrucciones De Uso página 25

OBJ_BUCH-0000000131-002.book Page 25 Thursday, January 23, 2014 1:23 PM
Roughing (figure 12).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the power
tool and move it over the surface.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 13).
Always work in an up-grinding motion,
so that the cutting disc will not jump out
of the cut.
Fig.12
Fig.13
en
25