OBJ_BUCH-0000000221-001.book Page 16 Tuesday, July 21, 2015 8:42 AM
en
16
Switching on and off (figure 8).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
For stationary use in a drill stand, remove the
switched off power tool from the drill stand
at operating temperature every 50 operating
hours and turn it by 180° to achieve uniform
lubrication.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Locking on:
Press the On/Off switch to the stop and press
in the Locking button.
Release the On/Off switch.
For switching off, briefly press the On/Off
switch until the Locking button disengages.
Release the On/Off switch.