Setting Of Position - Velux KLF 100 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setting of position

F G
Positions UP and dOWN
Setting of position is used to run products to a position
between 0% and 100% at intervals of 10%. As default
(factory setting) the products will travel to maximum top
or bottom position.
Position table
Entry
Default
Blinds and shades
Skylight
The position indication for VELUX products corresponds
to the display information on a VELUX remote control.
This applies to all product types except Skylight. You are
therefore recommended to use the position table when
setting the position. Always check the position settings
when the installation of the interface/repeater unit has
been completed.
Note: You can also choose manual operation. In this case,
the products will only be activated as long as the external
control device is active.
20 VELUX
0%
100%
Up
Down
Open
Closed
ENGLISH
C
A B C D E F
G
H
POSITIOn DOWn
90 %
100 %
Manual
Enter
Back

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Klf 100 3lf s01 us/au

Tabla de contenido