Intended Use; Installation And Connection - Pontec PondoCompact 2000 Instrucciones De Uso

Delivery scope and unit configuration
5 A
PondoCompact
2000 3000
Quantity Quantity
1 1 1
2 1 1
3 1 1
4 1 1
– –
5 1 1
– –
6 4 4

Intended use

PondoCompact, referred to as "unit", may only be used as specified in the following:
· For pumping clear water used for indoor and outdoor fountain pumps, table fountain pumps and statues.
· Operate in accordance with instructions.
The following restrictions apply to the unit:
· Do not use in swimming ponds.
· Never use the unit with fluids other than water.
· Never run the unit without water.
· Do not use for commercial or industrial purposes.
· Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
· Do not connect to the domestic water supply.

Installation and connection

W A R N I N G
Death or serious injuries from hazardous electrical voltage due to operation of this unit in a swimming pond.
· Never operate this unit in a swimming pond.
Operation under water
How to proceed:
5 B
1. Fasten the suction cups to the pump.
2. Screw the hose connector with O ring onto the outlet and hand tighten.
3. Set the flow rate (pump delivery rate).
– The regulator for setting the flow rate is located at the back of the filter housing.
– Turning the regulator clockwise: Increases the flow rate.
– Turning the regulator counterclockwise: Decreases the flow rate.
4. Fit the hose to the hose connector and install the pump underwater on a firm surface in a horizontal position.
– The pump can be fixed to a smooth, clean surface with the suction cups.
Description
5000
Quantity
1 Motor housing
1 Pump casing
1 Filter housing
– Inlet connection: 19 mm (¾ '') hose connector with union nut and flat seal
1 Inlet connection: 25 mm (1 '') hose connector with union nut and flat seal
– Outlet connection: 19 mm (¾ '') hose connector with external thread and O ring
1 Outlet connection: 25 mm (1 '') hose connector with external thread and O ring
4 Suction cups
- EN -
11