Remedy Of Faults - Pontec PondoCompact 2000 Instrucciones De Uso

- EN -
Operation out of the water
· Do not expose the unit to direct sunlight.
How to proceed:
5 C
1. Remove the filter housing.
– The filter housing is not required for operation out of the water.
2. Fasten the suction cups to the pump.
3. Screw the hose connector with O ring onto the outlet and hand tighten.
4. Screw the hose connector with flat seal and union nut onto the outlet and hand tighten.
5. Set the flow rate (pump delivery rate).
– Turning the regulator clockwise: Increases the flow rate.
– Turning the regulator counterclockwise: Decreases the flow rate.
6. Fit one hose to the hose connector at the inlet and one to the hose connector at the outlet, and install the pump on a
firm surface in a horizontal position.
– To prevent air from being taken in, ensure that the pump and the hose to the inlet always remain below the water
level.
– The pump can be fixed to a smooth, clean surface with the suction cups.
Commissioning/start-up
C A U T I O N
Risk of injury due to fast rotating components.
A temperature monitor switches the unit off automatically in the event of overload and on again once it has
cooled down.
· Isolate the unit before starting any work.
N O T E
Never allow the pump to run dry. Otherwise the pump will be destroyed.
· Ensure that the pump is always flooded during operation.
· Regularly check the water level.
· Switching on: Insert the power plug into the socket.
– The unit switches on immediately.
· Switching off: Disconnect the power plug.

Remedy of faults

Malfunction
The unit does not start up
Insufficient fountain height
Unit switches off after a short running period
12
Cause
No mains voltage
Impeller unit blocked
Regulator closed too far
Filter housing or impeller unit soiled, hose
blocked
Hose defective
Hose kinked
Impeller unit worn
Filter clogged
Water temperature too high
Remedy
Check the mains voltage
Clean
Adjust regulator
Clean
Replace
Route hose in a straight line
Replace impeller unit
Clean
Adhere to max. permissible water temperature
(® Technical Data)