Intended Use; Installation And Connection - Pontec PondoCompact 300i Instrucciones De Uso

Information about these operating instructions
You made a good choice with the purchase of this product PondoCompact.
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit.
Ensure that all work on and with this unit is only carried out in accordance with these instructions.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new
owner.
Product Description
Delivery scope and unit configuration
 A PondoCompact
300/300i
Quantity Quantity
1 1
2 1
3 –
4 –
5 2
Properties
PondoCompact pumps are designed for water features.
• PondoCompact 300i: Suitable for indoor use.
• PondoCompact 300iL: Suitable for indoor use, with integrated lighting.
• PondoCompact 300: Suitable for indoor and outdoor use.
• Simple regulation of the water volume.
• 13 mm (½ '') hose connection.

Intended use

Only use the product described in this manual as follows:
• For operation with clean water.
• Operate the product in compliance with the technical data.
The following restrictions apply to the unit:
• Do not use in swimming ponds.
• Never use the unit with fluids other than water.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
• Do not connect to the domestic water supply.

Installation and connection

WARNING
Severe injuries or death due to operation of this unit in a swimming pond. Defective electrical components will electrify
the water with dangerous electrical voltage.

Never operate the unit in a swimming pond.
How to proceed:
 B
1. Set the flow rate:
– Turning the socket clockwise: Increases the flow rate.
– Turning the socket counterclockwise: Decreases the flow rate.
2. Fit the hose onto the outlet.
 C
3. Install the pump fully submerged.
– Ensure that the maximum permissible submersion depth of 1 m is not exceeded
– Route the power cable so that it forms a loop below the power socket.
4. PondoCompact 300iL: Die Anschlussleitung der Pumpe mit dem Steckertrafo verbinden.
Description
300iL
1 Motor housing
1 Pump casing with outlet
1 Halogen lamp
1 Plug-in transformer
2 Suction cups
- EN -
9