To Cut Grass Without A Grass Catcher Or Mulch Plug Attached; To Get A Good Result; Maintenance; Maintenance Schedule - Husqvarna LC247Li Manual De Usuario

1. Release the motor brake handle to stop the motor.
(Fig. 40 )
2. Press the ON/OFF button (A) on the control panel
and the green LED (B) goes out.(Fig. 41 )
3. Open the battery lid and turn the safety key to 0.(Fig.
42 )
4. To remove the battery, press the two release buttons
and pull out the battery.(Fig. 43 )
5. Charge the battery if it is weak. For more
information, refer to
13 .

To get a good result

• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Do a general inspection
Clean the product
Do a check of the start inhibitor *
Make sure that the safety devices on the product are not defective *
Examine the cutting equipment
Examine the cutting cover *
Do a check of the motor brake handle *
Make sure that the ON/OFF button operates correctly and is not defective
Examine the battery for damage
Do a check of the battery charge
Make sure that the release buttons on the battery operates correctly and that the
battery locks into the product
Examine the battery charger for damage and make sure that it operates correct-
ly.
14
To charge the battery on page
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
To cut grass without a grass catcher or
mulch plug attached
• Lift up the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass discharges
below the rear cover.

Maintenance

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 10 .
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
429 - 002 - 13.12.2017