High Load Function; Automatic Restart; To Stop The Product; To Get A Good Result - Husqvarna LC 142i Manual De Uso

High load function

When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.

Automatic restart

During operation, the blade and motor can temporarily
stop because of obstacles such as grass blockage
below the cutting cover. If this occurs and you keep the
motor brake handle pushed down, the product tries to
restart automatically. If the product does not restart in 5
seconds, it can be necessary to clean below the cutting
To clean the product on page 15 .
cover. Refer to
WARNING:
cutting cover, release the motor brake
handle, turn the safety key to 0, remove
the battery and wait at minimum 5 seconds.
There is a risk of injury if the obstacle is
removed and the product accidentally starts.

To stop the product

WARNING:
before you let the product out of view.
1. Release the motor brake handle to stop the motor.
2. Open the battery lid and turn the safety key to 0.
14
Before a check of the
Turn the safety key to 0
3. To remove the battery, push the 2 release buttons
and pull out the battery.
4. Charge the battery if it is weak. For more
information, refer to
12 .

To get a good result

• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Keep the cutting cover clean. Buildup from grass
and dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
product on page 15 .
To cut grass without a grass catcher or
mulch plug attached
• Lift up the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass discharges
below the rear cover.
To charge the battery on page
To clean the
1692 - 003 - 15.12.2021