Makita SL 7000 Manual De Instrucciones página 3

ENGLISH
A Rigging tube
B Use on the ceiling
C
Use on the wall
SPECIFICATIONS
Model ............................................................
Rated power ...................................................
Rated speed ...................................................
Ø max sand paper ...........................................
Spindle thread ................................................
Lenght ...........................................................
Net weight ......................................................

Due to our continuing program of research and
development, the specifications herein are subject to
change without notice.

Note: Specifications may differ country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate and
can only be operated on single-phase AC supply.
They are double insulated in accordante with European
Standard and can, therefore, also be used from sockets
without earth wire.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.
Safety instructions
1. This power tool is intented to function as a san-
der. Read all safety warnings, instructions, illu-
strations and specifications provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fire and/or serious
injury.
2. Operations such as grinding, polishing, wire
brushing or cutting-off are not recommended to
be performed with this power tool. Operations for
which the power tool was not designed may create a
hazard and cause personal injury.
3. Do not use accessories which are not specifically
designed and recommended by the tool manufac-
turer. Just becouse the accessory can be attached
to your power tool, it does not assure safe operation.
4. The rated speed of the accessory must be at least
equal to the maximum speed marked on the
power tool. Accessories running faster than their
rated speed can break and fly apart.
Explanation of general view
1 Dust suction
2 Mechanical transmission
3
Switch
5. The outsider diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories can-
not be adequately guarded or controller.
6. The arbour size of discs, backing pads or any
other accessory must be properly fit the spin-
dle of the power tool. Accessories with arbour holes
that do not match the mounting hardware of the
power tool will run out of balance, vibrate excessively
and may cause lost of control.
7. Do not use a damaged accessory. Before each
use inspect the accessory such as sanding disc
for chips and cracks or backing pad for cracks. If
power tool accessory is dropped, inspect the
damage or install an undamaged accessory. After
inspecting and installing an accessory, position
yourself and bystanders away from the plane of
the rotating accessory and run the power tool at
maximum no-load speed for one minute. Damaged
accessory will normally break apart during this test
time.
8. Wear personal protective equipment. Depending
on application, use face shield, safety goggles or
safaty glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron
capable of stopping small abrasive or workpiece
fragments. The eye protection must be capable of
stopping flying debris generated by various opera-
tions. The dust mask or respirator must be capable of
filtrating particles generated by your operation. Pro-
longed exposure to high intensity noise may cause
hearing loss.
9. Keep bystanders a safe distance away from work
area. Anyone entering the work area must wear
personal protective equipment. Fragments of wor-
kpiece or of a broken accessory may fly away and
cause injury beyond immediate area operation.
1
4 Electronic speed control
SL 7000
500 W
800 - 1.450 min ˉ ¹
225 mm
M14
150 cm
4,6 Kg.