Televes 2311 Manual De Instrucciones página 5

GENERAL INSTALLATION CONDITIONS
EN
• Before handling or connecting the equipment, please read this manual.
• Do not obstruct the equipment' s ventilation system.
• Please allow air circulation around the equipment.
• Do not place the equipment near sources of heat or in excessively moisture conditions.
• Do not place the equipment where it may be affected by strong vibrations or knocks.
HOW TO USE THE EQUIPMENT SAFELY
• If any liquid or object falls inside the equipment, please contact a specialized technician.
• Do not connect the equipment until all the other connections have been made.
INSTRUCTIONS FOR THE OPTICAL CONNECTION
• For the optical connection, a single mode fibre cable is used with an SC/APC-type
connector.
• Remove the protective cover from the optical connector on the front panel of the device,
and the cap on the connector of the single fibre cable.
• Connect the cable to the device, carefully slotting the guides together for both connectors,
pushing the connector all the way in.
PRECAUTIONARY MEASURES WITH THE CONNECTION POINT
• Take special care to avoid damaging the unprotected ends of the connectors, as small
scratches, impurities and/or particles of dirt, oil, grease, sweat etc. may significantly affect
the quality of the signal.
• To clean the ends of the connectors, gently rub with a lint-free lens cleaning cloth,
dampened using additive-free isopropyl alcohol. Make sure the alcohol evaporates fully
before connecting.
• Keep the connector covers and cable caps in a safe place in case they are needed in the
future.
• Always fit the covers on the connectors of devices that are not connected to cables to
prevent the laser beam from damaging the eyes.
5