Joie i-Venture Manual De Instrucciones página 11

Ensure the enhanced child restraint
latched indicator on the base show
green so that i-Venture seat is
securely installed onto the base; if it
shows red that means the i-Venture is
incorrectly installed. -1
25
!
Pull up on the i-Venture seat to
make sure it is securely latched
onto the base.
!
Make sure that there is no gap
between the base and vehicle seat.
19
23
2
1
1
24
25
1
Securing your Child
Note
1. Please remove the infant insert when the child is in the forward
facing mode.
2. Please install the i-Venture and base (without the rebound bar
attached) on the vehicle seat, and then put the child in the
i-Venture seat.
3. After the child is placed into the i-Venture, check whether the
shoulder harnesses are at proper height.
1. Press the webbing adjustment
button, while pulling out the
shoulder harnesses to the proper
length.
26
2. Press the red button to disengage
the buckle as 15 .
3. Fix the buckles on the both sides of
the seat located on the both sides
of seat as shown to make placing
the child in forward facing mode
more convenient.
27
26
27
20