Stand-Alone Mode With Built-In Microphone; Master/Slave Mode - Luxibel LX110 Manual Del Usuario

Sens Sound sensitivity
U— User-defined colors
dim Dimmer speed setting
dim1: Dimmer speed fast
dim2: Dimmer speed middle
dim3: Dimmer speed slow
Fan Fan setting
auto : Moving with auto program
high: Moving with highest speed
Send Send data（linking fixture）
send1: Single fixture
send4 : 4 pcs linking
Slave mode（linking fixture）
SlA
SLＡ 1 : Same program with the master fixture
SLＡ 2 : Receive the second program data
SLＡ 3 : Receive the third program data
SLＡ 4 : Receive the fourth program data
7.2

Stand-Alone Mode with built-in microphone

In stand-alone mode, the device runs one of the built-in programs: automatic or sound-activated.
To set the device to stand-alone mode:
1. Connect nothing to the DMX input of the device.
2. Press <MENU> until <P--> is displayed and press <ENTER>.
3. Use <UP> and <DOWN> to select a built-in program:
7.3

Master/Slave Mode

The master/slave mode allows connecting several devices to a single master device. All slave devices will then
work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode.
1. Connect all devices in series with DMX cables.
2. The first unit in the chain functions as the master device. Set up the unit as described above.
3. On each slave device, press <MENU> until <SLA> is displayed and press <ENTER>.
4. Use <UP> and <DOWN> to select an option and press <ENTER>.
7.4 DMX Mode
This mode allows you to control the device by any universal DMX controller.
 All DMX-controlled devices need a digital start address so that the correct device responds to the signals.
This digital start address is the channel number from which the device starts to listen to the DMX controller.
The same starting address can be used for a whole group of devices or an individual address can be set for
every device.
 When all devices have the same address, all the units will listen to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set individual addresses, each device will listen to a separate channel number. Changing the settings of one
channel will only affect the device in question.
Example:
To use the 1-channel mode, set the start address of the first unit to 1 (CH1), the second to 2 (CH2), the third
to 3 (CH3), and so on. The highest start address is 512.
Use the table below to define the correct address. The table shows the settings for units 1 to 3. Apply the same
principle for all units and channels.
Channel mode
3 Start address
V. 01 – 21/03/2013
LX110
Start addresses
First unit Second unit
1 4 (1 + 3)
6
Highest start
address
Third unit
7 (4 + 3)
©Velleman nv
510