Product Description; Taking Into Use; Functions - Trotec BX11 Manual De Instrucciones

prOdUct dEScrIptION

B X 1 1
SET
Operating keys
Plug
LCD display

tAKINg INtO USE

Place three AAA R03/1 . 5V into your energy meter before you connect
it to an electrical consumer . In order to do so, first loosen the screw to
the battery compartment and then remove the lid . Make sure that the
battery poles are properly aligned . Be sure to screw the lid securely
into place again before actually taking your energy meter into use!
m
the display is now activated and can be configured accordingly.
please remember that these settings will be deleted when the
batteries are exhausted or when the batteries have been remo-
ved from the battery compartment when not connected to the
mains. to insert/replace the batteries, the device must not be
connected to the power supply! there is a risk of electric shock!
B - 3
AV
Plug
Operating manual – Energy cost measuring instrument
Degrees of contamination
The following are the degrees of contamination as specified according
to IEC 664:
- Degree of contamination 1
No or only dry non-conductive contamination .
- Degree of contamination 2
Dry, non-conductive contamination only . Occasional temporary con-
ductivity through dewing must be reckoned with .
Batteries
- Degree of contamination 3
Conductive contamination or dry, non-conductive contamination
which can become conductive can occur because of expected dewing .
- Degree of contamination 4
Contamination leads to consistent contamination because of conduc-
tive dust, rain or snow .

Functions

• Display
- time (24h) and day
- current energy consumption (W) and electricity frequency
- voltage, amperage and total recording time
- total energy consumption (kWh) and resulting costs
• Two programmable electricity tariffs
• Overload alarm and reset function
EN