dirna Bergstrom bycool green line compact Instrucciones De Montaje página 25

COMPACT
Fit the internal air distribution panel on the
11
front studs with M6 wide-flange washer (1)
and M6 nut (1) on each stud. Tighten nuts until
the foam rubber duct reaches the top foam
rubber on the device.
IMPORTANT: The rubber ducting must
being run into the upper rubber of the unit
to avoid air leaks.
11
EPDM
seal
Cabin ceiling
Upholstering
Tighten nut on point 10a until it reaches the
12
top of the internal air distribution panel.
12
EPDM
seal
Cabin ceiling
Upholstering
Place console and centre equipment in the
13
most convenient place of cabin roof. Once
centred, remove console for later installation.
Base
Nut M6
M6 stud
Base
M6 nut (10a)
M6 nut
M6 stud
Air conditioning for vehicles
Rubber ductings
Rubber ductings
25
Foam rubber
interior air distribution panel
Foam rubber
interior air distribution panel
EN