Husqvarna CR 125 2010 Manual De Uso Y Mantenimiento página 101

Ocultar thumbs Ver también para CR 125 2010:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

REASSEMBLING THE FRONT WHEEL
Fit the L.H. spacer on the wheel hub.
Fit the wheel between the front fork legs so that the brake disc
is fitted into the caliper.
Fit the wheel axle (2) from the R.H. side, after greasing it and
push it to the stop on the L.H. leg; during this operation, the
wheel should be turned. Tighten the screw (3) on the fork L.H.
side but DO NOT lock it. Now, pump for a while, pushing the
handlebar downwards until you are sure that the fork legs are
perfectly aligned.
Lock: the screws (1) on the R.H. leg (10,4 Nm/ 1,05 Kgm/ 7.7
ft-lb), the screw (3) on the L.H. side (51,45 Nm/ 5,25 Kgm/
38 ft-lb), the screws (1) on the L.H. leg (10,4 Nm/ 1,05 Kgm/
7.7 ft-lb).
Check that the brake disc slides between the caliper pads with-
out any friction.
2
1
NOTE
After reassembly, pump the brake control lever until the pads
are against the brake disc.
1
3
37

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wr 125 2010Wr 125 2010 usa

Tabla de contenido