Husqvarna CR 125 2010 Manual De Uso Y Mantenimiento página 119

REPLACING THE NUMBER PLATE LAMP (WR)
Pull out the number plate lampholder (4) from the back of the
vehicle. Pull out the lampholder and the bulb. Rotate the bulb
(5) to remove from the lampholder.
Once the bulb has been replaced, reverse the above procedure.
4
5
ADJUSTMENT OF HEADLIGHT (WR)
When checking the proper orienting of headlight, inflate tires
at right pressure, sat a person on the saddle and place the mo-
torcycle perpendicular with its longitudinal axis 10 meter (33
ft) from a wall or screen. Then trace an horizontal line equal to
the height of headlight center and a vertical one in line with its
longitudinal axis.
If possibile, execute this operation in a shadowy place.
When the low beam is on, the upper boundary limit between
dark and lit zone should be 9/10 th of headlight center from
groud.
Adjust the preadlamp aiming by turning screw (1) to lower or
lift the high beam.
1
55