Husqvarna CR 125 2010 Manual De Uso Y Mantenimiento página 91

REAR BRAKE PEDAL POSITION ADJUSTMENT
The position of the rear foot brake pedal as to the footrest may
be adjusted according to the individual needs. For the adjust-
ing proceed as follows:
- loosen the screw (1);
- turn the cam (2) in order to adjust the brake pedal idle
stroke (A);
- the operation done, tighten the screw (1).
The adjusting operation carried out, adjust the idle stroke of
the pedal as follows..
2
REAR BRAKE IDLE STROKE ADJUSTMENT
The rear brake foot pedal should have a (B) 5 mm (0.2 in.)
idle stroke before starting the true braking action.
Should this not happen, operate as follows:
- loosen nut (3);
-
operate the pump rod (4) to increase or decrease the idle
stroke;
- tighten nut (3) at the end of the operation.
WARNING
When the idle stroke figures are not met,
the brake pads will be subjected to a fast
wear that may bring to the TOTAL BRAKE IN-
EFFECTIVENESS.
1
CHECKING THE FLUID LEVEL
The level (A) must be set between the pump tank notches.
4
3
A
27